A "20 times stronger than epoxy" label shows up constantly in garage floor coating sales pitches, almost never with a source attached.
Mesa, AZ (PRUnderground) September 18th, 2026
A "20 times stronger than epoxy" label shows up constantly in garage floor coating sales pitches, almost never with a source attached. Nobody explains what was actually measured, under what conditions, or against which product--the number is simply presented as fact.
VIP Smart Storage, which installs epoxy flooring alongside its custom garage cabinets and storage systems, wants that number checked before a Mesa homeowner signs a contract based on it.
A Claim This Specific Needs a Real Test
The 1-day model leans on strength multiples and superior-penetration language, almost none of it backed by a recognized testing standard. Manufacturers cutting corners to save on materials and labor then market the shortcut as if it were an upgrade.
VIP Smart Storage is calling for independent, side-by-side testing covering:
Concrete penetration and adhesion
Moisture-mitigation performance
Impact and abrasion resistance
Comparative strength claims
Plasticizer migration and tire staining
Until that testing happens, a strength multiplier is a marketing decision, not a measurement.
The Problem With Quick-Install Garage Floor Coatings
Concrete is porous, so moisture below the slab migrates upward through microscopic channels, and once it reaches the surface, it converts to vapor that pushes outward against whatever is sealing the concrete.
A 1-day coating--typically polyaspartic--applied directly to bare concrete cures within hours, which sounds efficient but means it hardens before it can properly bond to the slab. Mesa's summer monsoons dump intense, fast-moving rain into the surrounding soil, and a thin coating is no match for the resulting moisture vapor transmission.
"There is nothing wrong with polyaspartic technology, we use it extensively ourselves," said Robert G. Hanson, President and CEO of Garage Floor Coating Franchise System Inc. "The problem is where it's being used. Rapid-cure polyaspartics and polyureas belong on top of the system, not directly on the concrete."
Quality Takes Time
VIP Smart Storage installs epoxy flooring over two days for a reason.
Day one covers mechanical surface preparation to open the concrete for a real bond, followed by a 100% solids moisture-mitigating epoxy primer and a full Torginol flake broadcast.
The crew returns on day two, once the epoxy has fully cured, to apply two coats of 100% solids polyaspartic topcoat. The result is a durable garage floor built to endure decades of abuse, not bubble and peel after a couple of years.
The corporations pushing 1-day coatings know their product can't withstand real garage conditions, so they often exclude damage from moisture vapor transmission, hydrostatic pressure, plasticizer migration (permanent tire staining), or general chemical staining--the exact failures a rushed garage flooring installation is most likely to produce.
If a coating is marketed as "stronger than epoxy," consumers should understand exactly which potential failures are, and are not, covered.
VIP Smart Storage continues pushing for independently verified testing behind such claims, so homeowners can make informed decisions.
